Configuring the security interfaces
65
WAN Access Routers Getting Started Guide
7 • Security
4. Leave Destination and Netmask both as 0.0.0.0 because this is the gateway default route.
5. Click on the
Update
button.
6. Seeing the green check mark under Valid indicates the IP addresses of the WAN service and the gateway
are properly configured. (See
figure 45
.)
Figure 45. Valid gateway route
Configuring the security interfaces
The interfaces and routes have been configured on the WAN Access Router. The Ethernet side of the WAN
Access Router will be configured to be an internal interface and the WAN side is selected to be the external
interface since it is on “public” side of the modem connection.
1. Go to the Security Interface Configuration webpage as follows Configuration Menu > Services Configuration >
Security. (See
figure 46
.)
Figure 46. Security configuration home page
Summary of Contents for LR120A
Page 1: ...LR120A LR121A LR122A LR125A WAN Access Routers Getting Started Guide...
Page 24: ...19 Chapter 2 Product Overview Chapter contents Introduction 20 Applications overview 21...
Page 115: ...110 Appendix B Cable recommendations Chapter contents Ethernet Cable 111 Adapter 111...
Page 128: ......
