69
Serial Port Profiles
Advanced Tab Field Descriptions
The
COMredirect Advanced
tab determines how the COMredirect connection is initiated and then
sets up the appropriate connection parameters.
Configure the following parameters:
Host Name
Specify the preconfigured host that will be in the multihost list.
Default:
None
TCP Port
Specify the TCP port that the Terminal Server will use to communicate to the
Primary Host
.
Default:
10000 + serial port number - 1 (so serial port 2 defaults to 10001)
Signals high
when...
When a COMredirect line becomes active, this option has the following
impact:
z
COMredirect Lite Mode
—When enabled, the EIA-232 signals remain
high (active) before, during, and after the COMredirect session. When
disabled, the EIA-232 signals remain low (inactive).
z
COMredirect Full Mode
—During the session, the COMredirect client
will be control the state of these signal before and after the connection.
Default:
Enabled
Enable Message of
the Day (MOTD)
Enables/disables the display of the message of the day.
Default:
Disabled
Idle Timeout
Use this timer to close a connection because of inactivity. When the
Idle
Timeout
expires, the Terminal Server will end the connection.
Default:
0
seconds so the port will never timeout
Range:
0-4294967 seconds (about 49 days)
Session Timeout
Use this timer to forcibly close the session/connection when the
Session
Timeout
expires.
Default:
0
seconds so the port will never timeout
Range:
0-4294967 seconds (about 49 days)
