TELCOLINK DT - AccessDSL NTU
User
Manual
Version: 2.5
Page 44 of 66
7.2.10.25
RS232RATE Command
SYNTAX: RS232RATE [n] or RSR [n]
This command sets the RS232 rate.
Parameters:
N
110, 150, 300, 600, 1200, 2400, 4800, 9600, 14400, 19200, 28800, 38400, 57600,115200
7.2.10.26
RS232ERATE Command
SYNTAX: RS232ERATE [n] or RSR [n]
This command sets the excess rate of the RS232 interface.
Parameters:
1
0 percent
2
0.5 percent
3
1 percent
4
2 percent
Note: for correct data transmission on rate 115200 via RS232 interface two stop bits must be used
AUTOR
NC
NC
NC
7.2.10.27
ST Command
SYNTAX: AUTORST [ON/OFF] or AR [ON/OFF]
This command enables/disables the restarting of the xDSL channel.
7.2.10.28
BASERATE Command
SYNTAX: BASERATE [n] or BR [n]
This command sets the base xDSL payload rate. This value must be between 3 and 32 and defines
the available 64 kbit/s channels.
7.2.10.29
ADAPT Command
SYNTAX: ADAPT [ON/OFF] or ADP [ON/OFF]
This command enables/disables rate adaption during startup.