Black & Decker 300 AMP JUMP-STARTER/INFLATOR Instruction Manual Download Page 2

3

• 

EXTENSION CORDS.

Make sure your extension cord is in good condition. When using an extension cord, be

sure to use one heavy enough to carry the current your product will draw. An undersized cord will cause a drop
in line voltage resulting in loss of power and overheating. The following table shows the correct size to use
depending on cord length and nameplate ampere rating. If in doubt, use the next heavier gage. The smaller the
gage number, the heavier the cord.

WA R N I N G :

This product or its power cord contains lead, a chemical known to the State of California to cause

cancer and birth defect or other reproductive harm. Wash hands after handling.

WARNING: BURST HAZARD: 

Do not use the unit for charging dry-cell batteries that are commonly used with

home appliances. These batteries may burst and cause injury to persons and damage property. Use the unit for
charging/boosting a LEAD-ACID battery only. It is not intended to supply power to a low-voltage electrical system
other than in a starter-motor application.

WARNING: SHOCK HAZARD:

• If an extension cord is used, make sure that:

a) the pins of extension cord are the same number, size and shape as those in the charger,
b) the extension cord is properly wired and in good electrical condition,
c) the wire size is large enough for the AC rating of the charger as indicated in the table on page 1.

• Do not operate unit with damaged cord or plug; or if the unit has received a sharp blow, been dropped, or

o t h e rwise damaged in any way. Do not disassemble the unit; take it to a qualified service technician when
s e rvice or repair is required. Incorrect reassembly may result in a risk of electric shock or fire, and will void
w a r r a n t y.

• Use of an attachment not supplied, recommended or sold by manufacturer specifically for use with this unit

may result in a risk of electrical shock and injury to persons.

• NEVER submerge this unit in water; do not expose it to rain, snow or use when wet.
• To reduce risk of electric shock, disconnect the unit from any power source before attempting maintenance or

cleaning. Turning off controls without disconnecting will not reduce this risk.

WARNING: RISK OF EXPLOSIVE GASES

• Working in the vicinity of a lead acid battery is dangerous. Batteries generate explosive gases during normal

b a t t e ry operation. For this reason, it is of the utmost importance that each time before using the jump-starter
you read this manual and follow instructions exactly.

• To reduce the risk of battery explosion, follow these instructions and those published by the battery

manufacturer and manufacturer of any equipment you intend to use in the vicinity of the battery. Review
c a u t i o n a ry markings on these products and on the engine.

• This equipment employs parts (switches, relays, etc.) that produce arcs or sparks. Therefore, if used in a garage

or enclosed area, the unit MUST be placed not less than 18 inches above the floor.

• THIS UNIT IS NOT FOR USE BY CHILDREN AND SHOULD ONLY BE OPERATED BY ADULT S .

CAUTION: TO REDUCE THE RISK OF INJURY OR PROPERTY DAMAGE:

• Pull cord by plug rather than cord when disconnecting the 120V AC Charging Adapter from the unit.
• NEVER ATTEMPT TO JUMP-STA RT OR CHARGE A FROZEN BAT T E RY.
• To recharge this unit, use only the supplied AC or DC Charging Adapter.
• Vehicles that have on-board computerized systems may be damaged if vehicle battery is jump-started. Before

jump-starting, read the vehicle’s owner’s manual to confirm that external-starting assistance 
is suitable.

• When working with lead acid batteries, always make sure immediate assistance is available in case of accident

or emergency.

• Always have protective eyewear when using this product: contact with battery acid may cause blindness and/or

severe burns. Be aware of first aid procedures in case of accidental contact with battery acid.

• Have plenty of fresh water and soap nearby in case battery acid contacts skin.
• If battery acid contacts skin or clothing, wash immediately with soap and water for at least 10 minutes and get

medical attention immediately.

PostScript  Picture

(Warning tirangle)

PostScript  Picture

(Warning tirangle)

PostScript  Picture

(Warning tirangle)

PostScript  Picture

(Warning tirangle)

PostScript  Picture

(Warning tirangle)

Minimum Gage for Cord Sets

Volts 

Total Length of Cord in Feet

120V

0-25

26-50

51-100

101-150

(0-7,6m)

(7,6-15,2m)

(15,2-30,4m)

(30,4-45,7m)

240V

0-50

51-100

101-200

201-300

(0-15,2m) (15,2-30,4m)

(30,4-60,9m)

(60,9-91,4m)

Ampere Rating

More

Not more

American Wire Gage

Than

Than

0   -

6

18

16

16

14

6   -

10

18

16

14

12

10 -

12

16

16

14

12

12 -

16

14

12

Not Recommended

2

SAFETY GUIDELINES / DEFINITIONS

D A N G E R :

Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.

WA R N I N G :

Indicates a potentially hazardous situation which, if not  avoided, could result in death or serious injury.

CAUTION: 

Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury.

C A U T I O N :

Used without the safety alert symbol indicates potentially hazardous situation which, if not avoided, may result in

property damage.

RISK OF UNSAFE OPERAT I O N .

When using tools or equipment, basic safety precautions should always be followed to

reduce the risk of personal injury. Improper operation, maintenance or modification of tools or equipment could result in
serious injury and property damage. There are certain applications for which tools and equipment are designed. Black &
Decker strongly recommends that this product NOT be modified and/or used for any application other than for which it
was designed. Read and understand all warnings and operating instructions before using any tool or equipment.

I M P O RTANT SAFETY INSTRUCTIONS

GENERAL SAFETY WARNINGS AND INSTRUCTIONS FOR ALL APPLIANCES

READ ALL INSTRUCTIONS

WA R N I N G :

Read all instructions before operating product. Failure to follow all instructions listed below may

result in electric shock, fire and/or serious injury.

AVOID DANGEROUS ENVIRONMENTS:

Don’t use appliances in damp or wet locations. Don’t use appliances in

the rain.

KEEP CHILDREN AWAY.

All visitors should be kept at a distance from work area.

STORE IDLE APPLIANCES INDOORS.

When not in use, appliances should be stored indoors in dry, and high or

locked-up place – out of reach of children.

DON’T FORCE APPLIANCE. 

It will do the job better and with less likelihood of a risk of injury at the rate for

which it was designed.

USE RIGHT APPLIANCE.

Do not use the appliance for any job except that for which it is intended.

DRESS PROPERLY. 

Do not wear loose clothing or jewelry. They can be caught in moving parts. Rubber gloves

and substantial, non-skid footwear are recommended when working outdoors. Wear protective hair covering to
contain long hair.

USE SAFETY GLASSES AND OTHER SAFETY EQUIPMENT.

Use safety goggles or safety glasses with side shields,

complying with applicable safety standards and, when needed, a face shield. Also use face or dust mask if
operation is dusty. This applies to all persons in the work area. Also use a hard hat, hearing protection, gloves,
safety shoes and dust collection systems when specified or required. Safety glasses or the like are available at
extra cost at your local dealer or Black & Decker Service Center.

DON’T ABUSE CORD.

Never carry appliance by cord or yank it to disconnect from receptacle. Keep cord from heat, oil,

and sharp edges.

DON’T OVERREACH.

Keep proper footing and balance at all times.

DISCONNECT APPLIANCES.

Disconnect the appliance from the power supply when not in use, before serv i c i n g ,

and when changing accessories such as blades and the like.

AVOID UNINTENTIONAL STA RT I N G .

Don’t carry plugged-in appliance with finger on switch. Be sure switch is off

when plugging in.

GROUND FA U LT CIRCUIT INTERRUPTER (GFCI)

protection should be provided on the circuits or outlets to be

used. Receptacles are available having built in GFCI protection and may be used for this measure of safety.

USE OF ACCESSORIES AND AT TA C H M E N T S .

The use of any accessory or attachment not recommended for

use with this appliance could be hazardous.

N o t e :

Refer to the accessory section of this manual for further details.

S TAY ALERT.

Watch what you are doing. Use common sense. Do not operate tool when you are tired.

CHECK DAMAGED PA RT S .

Before further use of the tool, a guard or other part that is damaged should be

carefully checked to determine that it will operate properly and perform its intended function. Check for alignment
of moving parts, binding of moving parts, breakage of parts, mounting, and any other conditions that may affect
its operation. A guard or other part that is damaged should be properly repaired or replaced by an authorized
s e rvice center unless otherwise indicated elsewhere in this instruction manual. Have defective switches replaced
by authorized service center. Do not use tool if switch does not turn it on and off.

DO NOT OPERAT E

portable electric tools near flammable liquids or in gaseous or explosive atmospheres.

Motors in these tools normally spark, and the sparks might ignite fumes.

• 

OUTDOOR USE EXTENSION CORDS.

When tool is used outdoors, use only extension cords intended for use outdoors

and so marked.

PostScript  Picture
(Warning tirangle)

PostScript  Picture
(Warning tirangle)

PostScript  Picture

(Warning tirangle)

PostScript  Picture

(Warning tirangle)

PostScript  Picture

(Warning tirangle)

JU300CB ManualENSP 072208.qxp  9/26/08  12:47 PM  Page 2

Summary of Contents for 300 AMP JUMP-STARTER/INFLATOR













Reviews: