www.bkte.pl
BKT ACBS - installation and configuration manual of the access control system with RS485 bus interface
74
The LED1 of the controller has been configured. The created
automation node that supports the diode should appear in the
system tree.
The above configuration should be sent to the controller. See
chapter 9.4 Data synchronising. After synchronization, the
controller will restart and the LED1 should light up when the door
or handle is open.
Similarly, configure the LED2, which will signal the opening of the
rear door of the cabinet.
9.10
Tamper signalling
Opening the controller box, the slave set box or the reader casing
can be monitored in the system as a sabotage. In order for the
sabotage condition to be saved to the database and at the same
time to be signalled by sound and led on the reader, the so-called
automation nodes must be used:
In the system tree, right-click on System->Networks->
->DataCenter (configurable name)->C1 (configurable controller
name)-> Automation Nodes and select Open.
Click Add
