Installation Manual
Fingerprint scanner and code keypad
3.2 On-wall installation
We recommend an installation height of between 1.2 and 1.4 m above finished floor level.
Fasten the on-wall housing. You can
use the enclosed screws (3.5 x 25) and
plugs for this.
Remove the terminal board by undoing
the two screws.
Push the terminal board into the groove
of the on-wall housing that has been
prepared for this.
Connect the supply line to the internal
unit accordingly at terminals 1 to 4.
0
Remove the back of the housing.
Note:
the module will not fit into the on-
wall housing with the back of the
housing attached.
Installation Manual, edition 3 dated 02/01/2013
Page 32
Copyright © BKS GmbH, 2012. All rights reserved.
C 59 501 107
