BIXOLON SRP-350 PlusA, User Manual

Page: 8 / 104

12
English
1-8. Using the Printer
Control Panel
Button
The button can be disabled by the ESC c 5 command.
Press the FEED button once to advance paper one line. You can also hold down the
FEED button to feed paper continuously.
Panel lights
POWER
The POWER light is on whenever the printer is on.
ERROR
This indicates an error.
PAPER OUT
This light indicates the near end of the paper roll. Install a new paper roll and the
printer Will continue printing.
When the light blinks, it indicates the self-test printing standby state or macro
execution Standby state when the macro execution command is used.
13
English
Serial Interface(RS-232C, RS-485) Specification
DIP Switch Set 1 Functions
SW FUNCTION ON OFF DEFAULT
1 Auto Line Feed Always
enabled
Always
disabled
OFF
2 Reserved - - OFF
3 Handshaking XON/OFF DTR/DSR OFF
4 Word length 7 bits 8 bits OFF
5 Parity check Yes No OFF
6 Parity selection EVEN ODD OFF
7 ON
8
Baud rate selection Refer to the Following Table
OFF
Baud rate selection
Transmission speed SW – 7 SW – 8
9600 baud ON OFF
19200 baud OFF OFF
38400 baud ON ON
57600 baud OFF ON
Dip Switch Set 2 Functions
SW FUNCTION ON OFF DEFAULT
1 Emulation STAR EPSON OFF
2 Reserved - - OFF
3 Reserved - - OFF
4
Busy
Condition
•Receive Buffer Full
•Offline
•Receive Buffer Full
OFF
5 OFF
6
Select
Print Density
Refer to the Following Table
OFF
7
Near End
Sensor Status
Disable Enable OFF
8 Reserved - - OFF
Print Density
Print Density SW - 5 SW – 6
1 ( Light ) ON ON
2 OFF OFF
3 ON OFF
4 ( Dark ) OFF ON