9
Assembly, commissioning
Assembly recommendations
Zone of installation of tracking device shall enable the connecting of
the pin to it and disable the possibility of accidental damage to the device,
moisture, impact of high temperature. Recommended location for
installation in the vehicle is an empty space under the dashboard inside
the vehicle; in addition, the device shall be placed in a way ensuring the
upper side with LEDs to face up.
The body of the device contains grooves for easy fastening with
plastic ties.
Electrical connections
Power supply wires are laid through the maintenance holes in the
body of the vehicle from the regular battery location to the place of
installation of the tracking device. Power wires are connected to the
corresponding battery terminals.
Carrying out welding work during the repair of the vehicle
necessarily requires disabling of power socket and peripherals.
The active state for discrete input with active "0" is a connection of
this input with the negative of the power (ground). The passive state for
this input is the lack of connection ("in the air" input).
The active state for the discrete inputs with active "1" is to supply to
these inputs the voltage exceeding + 8 V. The passive state for these
inputs is the lack of connection ("in the air" input).
Analog input voltage can range from 0 V to 27 V.
The discrete outputs of the device are made according to the scheme
such as "Open collector". The load shall be connected to the gap between
the discrete output and "+" power of the on-board network. When
activated, the output gets ground switching. Maximum current of the
discrete output load shall not exceed 0.5 A. If it is needed to switch higher
currents, connect digital outputs via additional relay.
The voltage on the discrete inputs shall not exceed 40 V.
The voltage on the analog inputs shall not exceed 27 V.
The power supply voltage of the device shall not exceed 36 V.
Otherwise, the device may be disabled.
Device to computer connection
The tracking device can be connected to a PC, in order to configure
the device, as well as to perform maintenance works. For this purpose, the
device is equipped with a service UART output. To connect to a computer,
