21
Notifications
Device can be configured to perform an outgoing voice call at
occurrence
of
certain
conditions.
Such a condition is a triggering of predetermined I/O element. Voice calls
shall be enabled in the general settings of the device. I/O element shall be
enabled, configured for one of the events (entry to the range, exit out of
the range, entry/exit in/out of the range), its ID shall be defined as a
trigger of outgoing call; Phone0 authorized phone number shall be defined.
An additional condition includes finding of the device in the coverage
area of GSM-operator and sufficient funds in the account. At the absence
of coverage the pursuant outgoing call will be postponed until the moment
when the device gets into the coverage area. The device performs one
attempt to make a voice call, per each trigger.
Setting to configure alerts are provided in the "Security" section in
Appendix 1. Authorized phone number Phone0 is recorded in the
parameter ID 0261.
In addition to a voice call, the device can send SMS to the authorized
phone number when the events occur. ID of I/O element,
which is used to send SMS, shall be defined as a trigger for outgoing SMS
messages. In addition to the SMS message you can add customized text,
where the text length shall not exceed 30 characters in the Latin alphabet.
Roaming options
The tracking device "BI 530R TREK" is able to operate in two modes:
in the home network mode and in the operating mode with a
predetermined list of authorized operators. Operation mode is set with ID
0917 parameter.
In the home network mode (ID 0917 = 0), the device makes
attempts to register in a home network of installed SIM-card.
List of authorized operators is not used.
Operating with a predetermined list of operators (ID 0917 = 1), the
device
checks
the
list
of
approved
operators.
If the list is empty, the device acts like in a mode of operation in a home
network. If the list is not empty, the device scans for available networks.
If there are any networks, included in the list of authorized ones, the device
makes an attempt to register in one of the authorized networks. After
successful registration, the device will be connected to the selected
network until it is available. At the loss of network signal the process will
be repeated. If the device does not detect the allowed networks enabled
in the list, or it is not able to register within the network, device module
will go to sleep mode within a certain timeout, after which the process will
be repeated.
