Bistos BT-740, Operation Manual

Page: 37 / 122

BT-740 Operation manual
36
P/N : 740-ENG-OPM-EUR-D03 Bistos Co., Ltd. 2018.05

Select [Settings]Smart Hotkey or press [Setting] key on the monitor
panel
→ “
Settings
”
;

Select “ Demo Mode>> ” → enter the password and confirm, and the monitor
enters the demo mode.
• Exit demo mode:

Select [Settings]Smart Hotkey or press [Setting] key on the monitor
panel
→ “
Settings
”
;

Select “ Exit Demo >> ” and the monitor exits the demo mode.
WARNING

The demo mode is mainly used to show the monitor’s performance and for
user training. In actual clinical use, the demo function is prohibited in order to
avoid mistaking the displayed waves and parameters as those of the patient,
thus affecting patient monitoring, and delaying diagnosis and treatment.
3.5 Measurement setup
This section only describes the general settings of measuring wave in monitor mode; for other
specific settings of each parameter, please refer to the appropriate section.
Select the wave area of a parameter to enter the appropriate setup menu. The setup menu
defines the specific wave setup of the parameter, such as wave gain and wave speed. You may
set the waves of different parameters as needed.
3.6 Freezing waves
In the patient monitoring process, you can freeze the wave on the screen, review and carefully
observe the patient's condition during this time. Freeze / unfreeze the wave as follows:
Select
【
Freeze
】
hotkey or press the [Freeze] key on the monitor panel to freeze the
displayed wave of the monitor.
Select
【
Freeze
】
hotkey or press the [Freeze] key on the monitor panel again to
release the freezing state.