Bissell HYDROCLEAN COMPACT 1991 Series, User Manual

Page: 17 / 40

www.BISSELL.com
17
Cleaning Machine After Use
WARNING
To reduce the risk of electric shock, turn power switch off and disconnect plug from
electrical outlet before performing maintenance or troubleshooting checks.
Hold the plug
and press the
cord rewind
button.
Disconnect solution
hose from connector
by pushing in on
either indented side
of connector. Solution
hose will pop out of
connector.
Remove hard floor
attachment by pressing
tab on front of tool and
pulling down to unlock
from tool. Then, push in
button on side of tool to
release attachment.
1 2
3 4
NOTE:
Cleaning solution can be left in the solution tank for next use.
Remove all tools that
were used and rinse
clean under running tap
water. Allow to air dry
completely before storing.
Store all cleaned and
dried separators and
tools in tool storage bag.
Store cleaner and tool
storage bag in protected,
dry area at room
temperature (4⁰ to 43⁰ C).
Disconnect hose and
empty any residual water
in a sink. Run tap water
through hose to rinse clean.
Allow to air dry completely
before storing.
5
7 6
If wet clean hard floor
attachment was used,
remove squeegee or
mopping insert. Remove
mop pad from mopping
insert and wash in a
machine.
Solution hoses can be
removed from wet clean
tools by pulling spray tip
out of tool.
8
WARNING
To reduce risk of a leaking condition, do not store cleaner in a standing, upright position or
where freezing may occur. Damage to internal components may result.