Bissell HYDROCLEAN COMPACT 1991 Series, User Manual

Page: 15 / 40

www.BISSELL.com
15
Wet Cleaning: Hard Floors
NOTE:
Do not pull cable out any further than yellow caution indicator on cable.
If pulled beyond red warning indicator on cable, damage will occur to cord
rewind system.
Pull cable out from back
of body and plug into a
proper electrical socket.
Press the wet
clean control on
the control panel.
Push power button on.
HELPFUL TIP
If cleaner loses suction, stop wet cleaning and check collection tank as
suction will shut off when float inside collection tank reaches full level. If
cleaner stops spraying, immediately press power button off and check
solution tank level.
5 7 6
CLEANING WITH SQUEEGEE INSERT
Rest squeegee on hard floor surface and press spray trigger to moisten floor
with cleaning solution while pulling tool back towards you. Release spray
trigger, tilt tool forward and pull back across cleaned floor with stationary
squeegee engaged to remove any residual water. Continue to clean entire
surface with wet then dry backwards strokes.
ATTENTION
Do not over saturate mop pad.
8
CLEANING WITH MOPPING INSERT
Rest mop pad on hard floor surface and press spray trigger
to moisten pad with cleaning solution. Move tool back
and forth as needed, using solution and mop pad to clean.
Release spray trigger, tilt tool forward and pull back across
cleaned floor with stationary squeegee engaged to remove
any residual water. Continue to clean entire surface with wet
mopping strokes and then dry backwards strokes.