Bissell HYDROCLEAN COMPACT 1991 Series, User Manual

Page: 18 / 40

www.BISSELL.com
18
Maintenance: Pre-Motor Filter
WARNING
To reduce the risk of electric shock, turn power switch off and disconnect plug from
electrical outlet before performing maintenance or troubleshooting checks.
Remove filter door by
pulling up on tab on front
of filter door, lifting out of
cleaner and setting aside.
1 2
3
Remove bottom
pleated filter. If
filters are dirty,
replace with new
filters or rinse clean
under running tap
water. Allow to
air dry completely
before placing back
into cleaner.
Once filter door is
removed, lift out top
foam filter.
Maintenance: Post-Motor Filter
Open top cover and remove
collection tank and solution
tank; set aside.
4 5
To re-attach filter
door, insert two
tabs on back of
door into notches
in pre-motor
filter opening and
pushing down on
door until tab on
front locks into
place.
1 2 3
Filters are located on inside
of filter door. Remove filter
door by pushing tab on side
of filter door in and pulling
out of cleaner.
Remove top foam filter
and bottom sponge filter.
If filters are dirty, replace
with new filters or rinse
clean under running tap
water. Allow to air dry
completely before placing
back into filter door.
To re-attach filter door,
insert two tabs on side
of door into notches in
side of post-motor filter
opening and push door
back in to place until tab
on opposite side of door
locks into place.