Separate the Outer foam and Inner pleated Circular Filters. Wash each
individually by hand in warm water. Mild detergent may be used if
desired. Rinse well, then air dry thoroughly before putting them back
together and replacing in Filter Cup.
The Filter Cup may be washed in warm water with a mild detergent.
Make sure it is completely dry before reassembling with filters.
The Upper Tank and Louvers may also be wiped clean with a damp
cloth. Reach underneath the Upper Tank and turn the rim of the Louvers
to unlock. Pull straight down to remove.
Unplug the cleaner from electrical outlet.
The Pre-Motor Filter protects the motor from debris. It is located
underneath the Dirt Container and Filter Cup in the center of the
round part of the Lock ‘n Seal Lever.
Remove the small round Filter and any debris on top of it. Rinse well
under warm water, then air dry thoroughly before replacing.
Use only BISSELL Style 9 Replacement Filters in your
BISSELL CleanView II.
Unplug the cleaner from electrical outlet.
The Post-Motor Filter assists in the filtration process to return
clean air to the room. It is located behind the door on the side
of the cleaner. When the filter becomes dirty, open the door,
remove the filter and replace. The white, pleated HEPA Media
Filter is not washable.
Note: A basic washable Post-Motor Filter with reduced
filtration is available if desired.
You should check your vacuum cleaner’s Rotating Floor Brush
and Drive Belt regularly for wear or damage. You should also
clean the brush and brush ends of strings, hair, and carpet
fibers. These can wrap around the brush and hamper its ability
to effectively clean your carpet. Also remove any debris that
has accumulated under the brush cover.
Unplug cleaner from electrical outlet.
Place handle in Low position and turn vacuum cleaner over so bottom
side is up.
Cleaning The Inner & Outer Circular Filters
9
4.
Cleaning the Pre-Motor Filter
1.
2.
WARNING:
Do not operate cleaner
with damp or wet
filters or without all
filters in place.
WARNING:
To reduce the risk of injury
from moving parts, turn
off vacuum cleaner and
disconnect Power Plug
from electrical outlet.
5.
6.
Replacing the Post-Motor Filter
1.
2.
3.
Pre-Motor
Filter
Post-Motor
Filter
1.
Check Rotating Floor Brush and Drive Belt
2.
ug603-2559_3574-3576_1005.indd 9
ug603-2559_3574-3576_1005.indd 9
1/4/06 9:45:57 AM
1/4/06 9:45:57 AM
