Bissell 20Q9, User Manual

Page: 13 / 16

Vacuum cleaner won’t pick up dirt continued
Possible Causes Remedies
Dirt Container not installed properly Position correctly and lock in place
Filters are dirty Check and clean Inner and Outer
Circular Filters, Pre-Motor and
Post-Motor Filters
Louvers missing or installed incorrectly Check for a clog in the tube in the
center of the Dirt Container, clear
and properly install Louvers
Tools won't pick up dirt
Possible Cause Remedies
Crack or hole in Hose Check Hose and replace if needed
Clog in vacuum Clear clog, see pg. 11-12
Dirt Container full Empty Dirt Container
Dirt Container or Upper Tank Position correctly and
not installed properly lock in place
Filters are dirty Check and clean Inner and Outer
Circular filters, Pre-Motor and
Post-Motor Filters
Louver missing or installed incorrectly Check for a clog in the tube in the
center of the Dirt Container, clear
and properly install Louvers
Vacuum cleaner is difficult to push
Possible Causes Remedies
Incorrect Height Adjustment Adjust Powerfoot to correct
height setting
Brush Cover installed incorrectly Make sure all four screws are in
place or all three latches are secured
Visible dirt escaping from cleaner
Possible Causes Remedies
Dirt Container full Empty Dirt Container
Filters missing or installed incorrectly Check Inner and Outer Circular
Filters and Post-Motor Filter for
correct installation
Dirt Container installed incorrectly Pull out and re-insert Dirt
Container correctly
Filter Cup installed incorrectly Remove Dirt Container and make
sure Filter Cup is fully attached
If suggested solutions do not correct the problem, call:
BISSELL Consumer Services
Troubleshooting Continued
13
3 3
4 4
5 5
6 6
1
1
1 1
2 2
3 3
2 2
4
4
10 10
11 11
12 12
1 1
2 2
ug603-2559_3574-3576_1005.indd 13 ug603-2559_3574-3576_1005.indd 13 1/4/06 9:45:59 AM 1/4/06 9:45:59 AM