Birmingham WSG1640AHD, Operating Manual

Page: 11 / 85

Operating Manual
3
before driving the machine.
(10) Must inspect if the spindle rotating direction is correct before driving the
spindle motor. Begin to grind work-piece after not less than 5 minutes
since driving the machine.
(11) Please clean the magnetic chuck surface before using, if there is
scuffing or scar on the surface, please grind it again.
(12) When grinding antimagnetic material such as aluminum alloy, graphite
and so on, please use suitable chuck block to fix the work piece and
make sure it could not touches the wheel.
(13) By hands before wheel turning, the operator should confirm if magnetic
chuck holding work-piece fast and hard.
(14) The work table must be motionless when operator adjusts right or left
travel limit control block.
(15) When wet grinding, should shut off cooling device before braking the
spindle motor.
Forbidden Items
:
(1) The machine is forbidden to install near the powder, magazine and
explosive.
(2) Don’t use inflammable liquid as cutting fluid.
(3) The wheel of spindle is forbidden to cut material as rotary sander.
(4) It’s forbidden to alter use & capacity design of the machine and to use
the wheel out of stipulation, also not processing overweight or
overlarge work-piece.
(5) Don’t change circuit before authorized by manufactory avoid damage.
(6) Don’t change interlocked circuit into by pass circuit.
(7) Don’t touch the parts at random where stuck heat lightning mark.
(8) Should avoid touching electrical box and circuit when body and hands
are wet.