BIRD SignalHawk SH-36S-RM-ASL, Operation Manual, Page: 24 / 195

PC/Rack Mount SignalHawk with ASL
10
Spectrum Analyzer Quick Start
CAUTION
Spectrum Analyzer has a +20 dBm (100 mW) max. RF input. Exceeding the maximum input
will damage the SignalHawk. If unsure of power levels, measure the test connection with a
power sensor before using the SignalHawk.
1. Measure the output power, or signal power, at the system's test port using a power
meter, service monitor, or equivalent.
NOTE
Ensure the output power is less than +20 dBm (100 mW).
2. Connect the SignalHawk's “RF Input” connector:
•
For low-power connections, connect directly to the output of the signal source.
•
For high-power connections, use a directional coupler or attenuator to reduce
the output level of the signal source.
3. Power up the SignalHawk.
4. In the Start Menu,click on Spec Analysis then click the Enter button (see Start Menu ).
5. In the Freq & Span Menu, set the frequency range (see Freq & Span Menu ).
6. In the Amplitude Menu, click on AutoScale after the first sweep. (see Ampt & Trace
Menu ).