Biotek EOS7150-H, Instruction Manual

Page: 5 / 32

CAUTIONS
This product is not intended for used by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning use of the product by a
person responsible for their safety. Children should
be supervised to ensure that they do not play with
the product.
Allow the product to dry completely when storing
the product in areas where it may freeze for a period
of time.
Do not drag the product over any surface while
attempting to move it.
Avoid using the product near radios, TVs,
computers, etc.
Must keep the product and/or the Lid Vent away from
fire or any source of ignition.
Pour only potable drinking water into the product.
The product should be located on a flat, level
surface for operation.
If the Power Cord is damaged, it must be replaced by
an appropriate cord or assembly made available by
the manufacturer or its service agent.
This product is shelf life sensitive. Do not store
for more than 6 months prior to installation and
operation.
Do not touch the Lid Vent or bring your hands near
the Gas Vent during heating.
Do not cover or block the Lid and/or Lid Vent with
anything such as a dishcloth.
Do not fill over the maximum Water Level Line.
Do not let the unit fall over. Do not lift, tilt, or shake
the unit or carry it by the lid.
Close the Upper Lid securely.
Do not slam the Upper Lid when closing.
Avoid rough handling, dropping or bumping the
product.
Do not use the product near a heat source or on top
of induction heating cookers.
Do not allow water to come into contact with the
Control Panel.
• Steam may result in scalds if the contained water is
hot.
• If water left inside freezes, it may cause breakdown or
malfunction.
• Doing so may cause damage to surfaces such as
countertops.
• The product may cause interference with certain
electronics.
• Do not use any open flame or other ignition source
within 25cm (10 inches) of the Upper Lid or Lid Vent.
• Poor water quality may have negative effects on your
health and the product. For hard water, please look for
pre-treatment solutions.
• Blockage can cause excessive internal pressure
which may damage the unit and void the warranty.
• Overfilling may cause water to spill out, resulting in
scalds if the contained water is hot.
• Doing so may result in scalds by hot water spilling out
from the Lid or Lid Vent.
• Water may spill out when the product is overturned,
resulting in scalds if the contained water is hot.
• Water may spill out, resulting in scalds if the contained
water is hot.
• Doing so may cause damage or cease operation of
the product.
• Doing so may cause fire, breakdown or damage of the
product.
• Doing so may cause product malfunction.
4