27
Symptoms
Causes and actions
All lamps of the main body are turned on.
(Still turned on even after the water flow is stopped)
No melody plays, even during the Acidic function.
Filthy odors, weird tastes and murky substances are not
eliminated.
●Is the water flow suspended?
=> When the water flows through, the indication will be
turned on. When it stops, the indication will be turned off.
●Is the electric plug disconnected?
=> Reconnect the plug.
●The system is malfunctioning.
=> After disconnecting the electric plug, you need to
contact the sales shop for advice.
* The power will not be turned on when the water
flow can not be detected due to the lower water pressure.
(Pressure of the tap water is less than 0.6kgf/cm2 )
●The system is malfunctioning.
=> After disconnecting the electric plug, you need to contact
the sales shop and request repair work.
●Check that the Acidic button has been selected.
*Allow water to flow and press the Acidic button.
●The filter performance is degraded.
=> Replace the filter.
●Is the water pressure low?
=> Open the water branch pipe for adjusting
(Contact the sales shop or the main office when the
problem is not solved even after the widest opening of the
water branch pipe)
●Is the water flow volume too high?
=> Adjust by the water supply control valve.
1) ERROR MODE: Error indication by ERR 3
(For overheating of electrolysis cell)
2) ERROR MODE: Error indication by ERR 7
(For Self-Cleaning failure)
3) ERROR MODE: Error indication by ERR OF
(For excessive water flow volume)
4) ERROR MODE: Error indication by ERR 8
(For a fake filter)
[000] is not displayed after filter replacement.
The filter use indicator is not visible.
1) Indication for a fake filter
- Need to replace with a genuine filter designated
by the company
2) Indication for the Self-Cleaning failure when letting water
flow through in the middle of Cleaning.
3) Indication for water flow volume exceeding 3.3 /Min.
4) Indication for a fake filter
- Need to replace with a genuine filter designated
●Did you insert the filter connector into the corresponding
port?
=> Insenrt the connector correctly.
●Check whether the filter is a genuine one made by the
company.
=>If a unbranded filter is installed, there will be a voice
guidance saying “Filter rejected, mount correct one” and the
power will be turned off after 20 seconds.
●Did you insert the filter connector while ionizer was unplugged.
=> Insert the power plug and put the filter connector into the port.
BTM-303D (영).indd 27
2016-08-31 오후 1:26:14
