12
Caution
● Do not install the product in the following areas:
- If not followed, malfunctioning can be caused.
•If vibration and impact can be fel
•If horizontality can not be acquired
•If direct sunlight comes in •If bathroom is installed or winds and rains can affect
•If there are lots of moisture or dust
•If there is a risk of breaking due to freezing
•lf heat of fire can be felt
•lf damage can be caused to the product
● You are required to contact the sales shop or the specialized installer for queries when
you attach the product to the wall.
● Improper mounting may result in the product falling of, accident or mal-function.
Should use the standard inlet hose (1/4”) and fix the valve cover in the direction of the hose to prevent the hose
from being bent or the fastening nut from being loosened. The safety pin needs to be inserted before using the
water.
●The product can be used conveniently by placing it on any place by applying the wall mounting or stand type
(Turn table) depending on the place of installation.
●After installation, connect the product to the power line.
●When the water flows through the product, the power will be turned on automatically. Then, select Purified
Water menu to enable the water branch pipe to open and close repeatedly to allow the water to flow for 2~3
minutes freely. Then push the pH button to set the desired concentration and compare it with pH comparison
sheet. The black water that will come out is the filter dusts flowing with water, not dangerous to the body.
(Refer to How to measure the pH value in Page 18)
● First of all, assembling the flexible pipe to the half-moon shaped alkaline water outlet at the
upper part by turning it clockwise.
1. Measure the distance between the place for installation and the adapter installed to the water tap and then
cut the hose with an extra length.
2.Cut the PVC hose for the acidic water into the length of 50~70cm and place it lower than the product.
A) When installing the product onto the wall
● Apply water to the installation drawing and place it onto the wall
while keeping the horizontality
● Of those nailing positions at the width (1~3) or the height (2 ~4),
choose the convenient ones for driving 2 nails
● Place the hanging holes of the product onto the nails
:Positions of nails
1. Using Flat-head driver, adjust the loundness.
2. Screwing yellow nail to left, volume will be up.
Screwing it to opposite, Volume will be down.
B) When placing the product on the sink deck and its supports.
-Place the main case of the product on an appropriate position.
● When the above steps are finished, use the hose to connect the
valve cock of the adapter to the inlet pipe at the bottom of the
main case of the water ionizer
5. Steps for assembling the component before installing them
6. How to install in different places
7. Audio volume control
BTM-303D (영).indd 12
2016-08-31 오후 1:26:10
