20
(Picutre 1)
(Picutre 4)
(Picutre 2)
(Picutre 5)
(Picutre 3)
(Picutre 6)
The filter without our company logo is not a genuine product. When a genuine filter is not used, the quality cannot
be guaranteed and the normal after sales service(A/S) will not be available.
How to replace the filter
■ Do not disconnect the electric plug.
(When the plug is disconnected, the system can be restored when the filter connector is inserted)
1.Open the cover and remove the filter. (Picutre1~3)
■ Be careful of the possible water coming out of the filter. (It is not leakage)
2.Replace with a new filter. (Picture 4)
■ Remove the sealing sticker of the filter.
■ Check whether the O-ring is attached well at the bottom of the new filter first. Then, place the filter into the hole securely
and turn it clockwise to insert it into the connection part. If a unbranded filter is installed, there will be a voice
guidance saying “Filter rejected, mount correct one.”, and the power will be turned off after 20 seconds.
3.Let the water flow through after selecting the purified water function.
■ Let the water flow through for about 2~3 minutes.
(Dusts of activated carbon which is the filtering medium may flow with water during the initial flow after the
filter is replaced.)
■ Check whether there is any water leakage at the installation section of the filter.
4.Insert the filter connector into the corresponding port (Picture 5)
■ Check whether the filter usage status indicating number becomes [000].
5.Close the cover. (Picture 6)
Please take note
■When you get the alkaline ionized water in a cup after the filter is replaced, there can be white bubbles.
which are not abnormal.
■The ion concentration (pH value) can become slightly higher after the filter is replaced (For about 1 week).
That is not abnormal.
Follow the steps mentioned above even when replacing the filter earlier than the time for the replacement.
BTM-303D (영).indd 20
2016-08-31 오후 1:26:13
