ALARM FUNCTION
When the Alarm is set to ON, the pH BOSS will sound
the beeper and disable the acid pump when the pH is
above or below the set point for more than 4 hours.
When the Alarm is set to OFF, the alarm will never be
triggered, regardless of the pH reading. Only
advanced users should set the alarm to OFF, and only
temporarily while the cause of the alarm beeping is
being rectified.
Use
PROGRAM / SET
to select Alarm.
!
Use the Use the
and
¯
buttons to select On or Off.
!
Press
PROGRAM / SET
to save.
!
Press
AUTO / OFF
to quit without saving changes.
When the alarm has been triggered, the pH BOSS will
sound the beeper and also display the following
message :
THE ACID PUMP WILL BE DISABLED AND THE pH
BOSS WILL NOT PUMP MORE DILUTED ACID
UNTIL THE ALARM HAS BEEN RESET.
You must press AUTO / OFF to reset the alarm and
return to normal operation.
The reason for the alarm being triggered should be
found and rectified too. It could be due to any of the
following :
Problem
...Acid drum is empty.
Fix
.............Make up a new drum of diluted acid.
Dilution ratio should be at least 4 parts
water to 1 part acid.
Problem
...Dose Setting is too low or too high.
Fix
.............See page 10 for information on how to
change the Dose Setting.
Problem
...pH Reading is incorrect
Fix
.............Re-calibrate the pH Probe. See page 12.
Problem
...pH Probe is broken or faulty.
Fix
.............If re-calibration is not possible, then
replace the pH Probe. See page 9.
A replacement pH Probe can be ordered
by telephone or online at
www.phboss.com or
www.bionizer.com.au
Problem
...Pump is not pumping acid correctly.
Fix
.............Check all tube and hose fittings for
leakage. Re-fit or replace as necessary.
Check squeeze tube inside pump for
leakage and replace if necessary. See
page 14.
A replacement Squeeze Tube can be
ordered by telephone or online at
bionizer.com.au
MANUAL DOSE
This will change from
0 to 5 Litres.
Use this function to add a measured dose of 1:4
diluted acid.
!
Use the
and
¯
buttons to enter 1 to 5 Litres.
!
Press PROGRAM / SET to start pumping.
!
Please note that the litres are the total litres of
liquid being pumped, and does not take into account
the dilution ratio of the acid. 1 Litre equals 200mL of
acid when the acid is diluted 1 part acid to 4 parts
water. Take care when using this function, that you
do not overdose the pool with acid.
CHANGING THE pH SET POINT
!
Use the Use the
and
¯
buttons to enter a new Set
Point value.
!
Press
PROGRAM / SET
to save.
Alternatively, press
AUTO / OFF
to quit without
saving changes.
Please note that the pH BOSS factory preset default
Set Point is pH7.4. This is most likely to be the best
setting for your pool, so changing the Set Point is only
recommended for experienced users.
11
PROGRAMMING YOUR pH BOSS
