Filter
For sand filters,
glass or silica sand
media provides
optimum results.
Filter
Pressure
Pool
Pump
Oxidizing
Pod
pH BOSS
Tee
Ionizing
Pod
BioDoser
Tee
6
BIODOSER INSTALLATION
READ THROUGH ALL STEPS BEFORE BEGINNING THE INSTALLATION.
BIODOSER INSTALLATION
NOTE:
Turn off all valves prior to fitting the T-piece
(avoid leaks), and turn them back on again before
switching pool pump back on.
1. Installing your BioDoser takes around 30
minutes.
TEE PIECE INSTALLATION
The BioDoser can be installed onto a new pool or an
existing pool with minimal pool preparation. As
always, ensure that the pool is correctly balanced.
2. Alternatively engage a competent person to do
the job.
3. If installing it yourself you will need :
!
PVC pressure glue and primer.
!
A fine tooth saw.
4. The Injection Tee must be fitted on the pipe that
sends water back to the pool after it has been
filtered (the “Return Line”).
The Injection Tee should be installed LAST in the
return line, after any other equipment,
including Bionizer products, Salt Chlorinator
Cell, Heater, etc.
1. For 50mm (2") pipe, cut out a 2.5cm (1") section
of pipe sufficient for the Injection Tee. For 40mm
(1.5") pipe, where the reducing bushes will be
used, cut out a 3.5cm (1.5") section of pipe.
2. If the Tee piece diameter is larger than the pipe
then use the 50mm to 40mm reducing bushes
provided by glueing them in place in the Tee
piece before fitting. The pipe should now fit
snugly into the Tee piece.
3. The Tee piece can be installed in any orientation.
HINT
: If you mount the Tee on a horizontal pipe
with the one way valve point downwards, then
the clear tube is less likely to kink over time.
If a heater is
installed, then
fit the BioDoser
Tee AFTER the
heater.
FLOW DIRECTION
