11
TROUBLESHOOTING
Unit is not adding liquid
when dosing pump is
operating
Unit does not power up
!
Replace power adaptor or cable. Please contact your distributor or Bionizer.
Faulty AC/DC power adaptor or DC Cable
!
Faulty BioDoser main unit. Return to Bionizer for repair.
!
Check that all suction and output hoses are fitted correctly, with no leakage.
Tighten Dosing Pump fittings further or replace with spare fittings (page 8).
!
Check that the supplement acid drum is not empty.
!
Check that squeeze tube inside pump is not leaking. Replace squeeze tube
and/or rollers as needed (see page 10).
WARNING : If any supplement has leaked out of hoses, wash down the area
with fresh water immediately. Take the lid off the pump, remove squeeze tube
and wash out with fresh water if squeeze tube was leaking.
If you need to return your BioDoser for service or repairs at any time, please use the manual dose function (page 9) to dose
1 litre (1 quart) of fresh water through the system before sending back. This will stop hazardous liquids leaking from the
pump during transport (which could damage your unit, voiding warranty), and is also a safety hazard for our technicians.
Symptom
Possible Causes and Remedies
TROUBLESHOOTING
