bintec elmeg RM7000, Installation Manual

Page: 11 / 33

Amber -> Auto-test.
Green -> Interface up (blinking, in some cards, when there is con-
nection data activity).
In addition to the LEDs described in the above table, the front panel also has LEDs linked to the Switch Ethernet in-
terfaces.
Fig. 2:
Ethernet interface LEDs
The table below provides information on the LEDs associated with the Switch Ethernet interface:
Switch Ethernet interface LED indicators
LED Description State
Orange PoE activity. Please see manual bintec Dm776-I
Power Over Ethernet.
Green Ethernet (link) connection estab-
lished. Off -> Link has not been detected.
Green -> Link detected. Blinking: con-
nection data activity.
3.1.2 Rear panel
The following figure shows the rear panel. Here you will find the majority of the RM7000 router connectors.
Fig. 3:
Rear panel
The following table provides information on each connector, as well as a description:
Rear panel components
Item Description
A Power source connection (PSU).
B Wi-Fi Antenna connectors. Not supported.
C 3G Antenna connectors. Not supported.
D SD. Slot used to insert an SD card.
E SIM Card. Not supported.
F Aux. Provides access to the RM7000 local console for configuring and monitoring
purposes.
G USB. Slot used to insert a 3G USB modem.
H 8-port Gigabit Ethernet Switch.
I PoE. Connector for power supply through Ethernet (Power over Ethernet).
bintec elmeg
3 Components and Power Supply
RM7000 7