bintec elmeg RM7000, Installation Manual

Page: 19 / 33

.......................................................................
.......................................................................
.......................................................................
.......................................................................
APP DATA DUMP..........................................................
Running application at: 0x00200140
Licence loaded successfully
Flash configuration read
Parsing text mode configuration ...
Configuration parsed
Initializing
Press any key to get started
Once the MiniPoE card has been installed, we can connect the PoE source to the device:
Fig. 16:
Connecting the PoE source to the device through the external PoE adaptor connector
3.6 RST button
The different RST button features are described below.
Fig. 17:
RST button
3.6.1 Rebooting the device
Once the device is operating normally, pressing the RST button will make it restart.
3.6.2 Default configuration
The RST button lets you boot the device with its default configuration through the following steps:
• With the device switched off, press and hold the RST button down while you turn the router on using the ON/OFF
switch (1).
• The PSU LED (green) will light up and LED 'S' will begin to blink (amber). It will carry on blinking for 10 seconds.
• To boot the device with the default configuration, let go of the RST button while LED 'S' is still blinking (i.e., before
the 10-second period expires).
The router's default configuration establishes the following access IP and mask address:
• IP address: 192.168.1.1
• IP mask: 255.255.255.0
Note
Some devices leave the factory with customized settings. This personalization may mean your router's
default configuration is different from the one shown above.
3.7 Connecting the data
The RM7000 has the following data connections.
bintec elmeg
3 Components and Power Supply
RM7000 15