3.5 Power source
The RM7000 is powered through an internal AC/DC source.
The RM7000 may also incorporate a card to inject PoE through the 4 ports of the 8-port Switch. In this case, an ex-
ternal adapter is needed to provide power to PoE module.
Warning
The equipment must be used with the power supply provided by the manufacturer.
Workplace Conditions. Main Characteristics
• Avoid humid and/or dusty locations.
• Direct exposure to sunlight and other heat sources should be avoided. The device should not be placed amongst
papers, magazines or other elements that could hinder natural air circulation.
• The device should not be placed very close to strong electromagnetic fields such as speakers, engines, etc.
• Knocks and/or strong vibrations should be avoided during transport, operation and storage.
Warning
The electric current in power cables, telephone lines and communication cables is dangerous. To pre-
vent electric shocks, before installing, handling or opening the equipment covers, connect and discon-
nect the cables following the steps set forth in
on page 12 and
on page 12.
3.5.1 Internal power source
To connect the power supply to the device, please follow the steps under section
on page 12.
To avoid electric shocks, residual current circulation and other unwanted effects that affect communications, the fol-
lowing is recommended:
Warning
All interconnected communication devices should be plugged to THE SAME GROUNDED POWER
OUTLET, which should at the same time be of good quality (lower than 10 ohms).
We recommend connecting all data devices to the same power source regardless of whether the work-
place is provided with an uninterrupted power supply (UPS), a regulated supply or is independent of the
other power supplies (such as lighting, etc.). This will help to prevent malfunctions and premature aging
of the drivers and other components.
3.5.1.1 Connecting
• Verify that the on/off power supply switch is in the OFF position.
• Connect all data cables.
• Connect the power supply to the device.
• Set the device’s on/off power supply switch in the ON position.
3.5.1.2 Disconnecting
• Set the on/off power supply switch in the OFF position.
• Disconnect the power supply from the device.
• Disconnect the data cables.
3 Components and Power Supply
bintec elmeg
12
RM7000
Summary of Contents for RM7000
Page 5: ...I Related Documents bintec Dm748 I Software Updating bintec elmeg Related Documents RM7000 1 ...
Page 7: ...Fax 49 911 688 0725 Email support bintec elmeg com bintec elmeg 1 About this Guide RM7000 3 ...
Page 23: ...Fig 27 Inserting SD card bintec elmeg 3 Components and Power Supply RM7000 19 ...
