Fig. 9:
Inserting the expansion card
(7)
Screw the tray to the device. See
Fig. 10
on page 10.
Fig. 10:
Screw the tray to the front panel
(8)
Connect a terminal to the console and check that the device detects the expansion card.
3.3 Installation in a rack
The bintec RM3000 device family can be installed in a 19” rack. The strips and screws needed are not provided by
default and need to be acquired separately.
Both strips are attached to the device by means of 4 screws, two on each side, as shown in Figure 11.
Fig. 11:
Anchor bolts for a rack
3.3.1 Standalone
The bintec RM3000 routers can be placed as a standalones on a flat, stable surface. The adhesive rubber feet must
be stuck to the underside panel to prevent the device from sliding.
3 Components and Power Supply
bintec elmeg
10
RM3000 Router
