20
MPR180416 Rev. B
www.bindicator.com
1.5 COPY FIRMWARE TO DISPLAY
Transfer firmware from a device to the local display interface.
1. Press RIGHT arrow to edit.
2. Press DOWN arrow to select START and RIGHT arrow key to begin the transfer.
3. SW UPLOAD will be displayed, then the device returns to Measurement Mode.
1.6 COPY FIRMWARE FROM DISPLAY
Transfer firmware from the local display interface to a device. Do NOT interrupt power during transfer.
1. Press RIGHT arrow to edit.
2. Press DOWN arrow to select START and RIGHT arrow key to begin the transfer.
3. SW DOWNLOAD will be displayed, then the device returns to Measurement Mode.
2. SETUP
Default settins are noted by asterisk (*) unless expliciitly stated.
2.1 Device
2.1.1 Long Tag: Text can be used in any way. A recommended use is as a unique label for a field device in a plant.
Limited to 32 ASCII characters. Read only on device. Read/write using SIMATIC PDM and AMS.
2.1.2 Tag: Text that can be used in any way. A recommended use is as a unique label for a field device in a plant.
Limited to 8 ASCII characters. Read only on device. Read only on device. Read/write using SIMATIC PDM and AMS.
2.1.3 Descriptor: Text that can be used in any way. Limited to 16 ASCII characters. No specific recommended use. Read
only on device. Read only on device. Read/write using SIMATIC PDM and AMS.
2.1.4 Message: Text that can be used in any way. Limited to 32 ASCII characters. No specific recommended use. Read
only on device. Read only on device. Read/write using SIMATIC PDM and AMS.
2.1.5 Installation Date: Date the device was first commissioned. Read only locally. Can be written via HART
(dd mm yyyy)
2.1.6 Hardware Revision: Read only. Corresponds to the electronic hardware of the unit.
2.1.7 Firmware Revision: Read only. Corresponds to the firmware that is embedded in the unit.
2.1.8 Loader Revision: Read only. Corresponds to the software used to updat the unit.
2.1.9 Menu Timeout: Time menu stays visible before switching back to Measurement view if no key is pressed
Values Range from 15 to 65535 s; Default is 120 s
2.2 Sensor
2.2.1 Units: PV (Primary Value) and SV (Secondary Value) units. Used in setting High/Low Calibration Point and .
displayed on LCD and in PDM
Values: meter*, centimeter, millimeter, ft, in, percentage
Changing units to percent (%) will update the mA setpoints.
