69
End IP Address:
the end IP address f the range the DHCP Server used to assign to the Clients.
Leased Time:
Set the leased time for each DHCP Client.
Static IP List:
The specified IP will be assigned to the corresponding MAC Address listed in the following table
when DHCP Server assigns IP Addresses to Clients.
Press
Add
to the Static IP List.
Enter the MAC Address, IP Address and Host Name, then click Apply to confirm your settings.
L
DHCP Server Relay
If you check
DHCP Relay
then you must enter the IP address of the DHCP server which assigns an
IP address back to the DHCP client in the LAN. Use this function only if advised to do so by your
network administrator or ISP.
Configure the second IP Address and Subnet Mask for LAN interface:
This function allows the creation of multiple virtual IP interfaces on this router. It helps to connect two
or more local networks to the ISP or remote node.
IP Address:
Specify an IP address on this virtual interface.
Netmask:
Specify a subnet mask on this virtual interface.
Click
Apply
to apply your settings.
Summary of Contents for BiPAC 7700N
