The battery
The battery is placed under the rear luggage carrier. The
battery is removable, rechargeable and provided with a
watertight housing.
Charging your battery
Make sure that your battery charger is compatible with
your local electricity network.
Warning! Only use the supplied charger that comes with
your e-bike. The use of non-original battery chargers
will void your warranty.
Non-original battery chargers may cause heavy injuries
to the user such as burns and electrical shocks as well as
damage to the e-bike and the battery.
Recharging the battery separately from the bike
Your battery can be recharged when it is removed
from you e-bike. You can unlock the battery with the
key provided with your e-bike and remove it from the
bike. Comes in handy when the battery needs to be
recharged and even preferable when you will not use
your e-bike for a longer period of time.
Charging and re-charging the battery
1. Open the rubber seal on the left side of the battery
(A) and put the battery charger plug (B) in the battery
socket.
2. Connect the power cable (C) to the battery charger
and put its plug into the wall socket.
3. The red LED (D) indicates that the battery is being (re)
charged.
Charging time
The Li-ion battery needs approximately 5 till 9 hours to
become fully charged.
Tip: The first three times you recharge your battery,
do a completely charging cycle of the battery. Keep
the battery charger connected during 24 hrs. This will
increase the lifetime of your battery.
Disconnect the battery charger
The battery is fully charged when the green LED is lit.
1. Remove the power cable (C) from the wall socket and
then the battery charger plug from the battery (B).
Close the rubber seal on the battery (A)
2. Store the battery charger after use.
A
B
C
D
The display can also show the following in addition to
the functions described above:
Error:
Following are the error codes that can be displayed:
21 * current abnormality * inspect if motor short
circuits * 22 * throttle abnormality * inspect if throttle
recovers original state * 23 * motor abnormality * is
the motor phrase well conected? Are the lines well
connected? * 24 * controller abnormality * is the motor
phrase well conected? Are the lines well connected? *
25 * brake abnormality * are the brakes in their original
state before display startup? 30 * communication
abnormality * are lines well conected between display
and controller?
You can check if the lines are well connected and try
to reconnect them. Better leave that to a professional
bicycle repair man.
General settings:
You may set the wheel diameter, speed limit and
backlight. The wheel diameter is set correctly in the
factory.
Press button B(+) and C(-) at the same time for at least
2 seconds after you activated the display. You entered
setting menu mode. Press (A) on/off for 2 seconds to
quit the setting menu.
Wheel diameter: press + or - button to select the correct
value to match the wheel diameter (16, 18, 20, 22, 24,
26 inch, 700C and 28 inch.) Press button (A) briefly to
confirm and enter the next setting.
When the running real-time speed is faster than the
value of limited-speed you set, the controller will cut off
the motor power to protect the rider’s safety. Limited
speed default setting value is 25 km/h. Press button (A)
briefly to enter the next setting.
You may set the backlight brightness in one of three
values. Press (B) + or (C) - in bL mode (backlight) and
confirm by pressing (A). Deault level is 1 (low).
