CAUTION
7
[If it is necessary to set a very precise angle]
Changing the cutter angle will also change the cutter direction.
After adjusting the cutter angle, always check the cutter direction and adjust it if necessary.
Hold the Head Case by hand and swivel it to the selected angle. To set an angle, use the line
marker on the Connection Case and the cutter angle’s scale on the Head Case. (Page 4 Fig. 2)
Rotate the Setting Plate in order to match the screw
holes of the Connection Case and tighten the (4)
Clamping Bolts temporarily. Due to the interference
with the Head Case there is (1) Clamping Bolt which
cannot be inserted. Insert this Clamping Bolt having
removed the interference by rotating the Head Case.
(Fig. 5)
Install the included Setting Disk to the Angle
Head. (Consult the page 11 “Installation of the
cutting tool”.) By touching the reference face
of the Setting Disk with a test indicator and
using the machine feed (example: XZ axes) as
shown in the figure, it is possible, by reading
the test indicator’s values, to check the
deviation of the cutter angle. (Fig. 6)
Use the short head of the included hex key to tighten the (4) Clamping Bolts uniformly.
Avoid interference
by swiveling the
Head Case
(Fig. 5)
(Fig. 6)
Insert
θ
2
θ
1
Cutter angle
Setting Disk
2
3
4
Z
X
(Example)
