OPERATION PROCEDURES
10
(Fig. 12)
(Fig. 13)
(Fig. 14)
Insert the Adjusting Rods in the side holes of the
Adapter Case, rotate the Adapter Case and
adjust the cutter direction. (Fig. 12)
It makes the adjustment easier to refer to the
value of the scale of the cutter direction that was
checked in the process [How to check the cutter
direction] on page 8.
(Fig. 13: Example of the cutter angle set to 15° )
[Example of the cutter angle set to 15°]
Following the example of “How to check the cutter direction” on page 8, the cutter is pointing toward
the 15° position of the scale of the cutter direction. Use this value as a reference point and turn the
Adapter Case to the selected direction. (Example here: parallel to the X axis)
By touching on to the reference face of the Setting Disk with a test indicator and moving in both right and left
directions, it is possible to check the parallelism of the cutter direction with the target direction. Inserting the
(2) Adjusting Rods in the Adapter Case at opposite positions will ease the fine adjustment. (Fig. 14)
Adjusting Rods
Cutter direction
Swivel
Rotate
Fine adjustment
Before adjustment
After adjustment
2
3
Reference face
Swivel
Y
X
