44
Pre-drill with a 3/16” drill bit before installing lag screws.
E:
Measure 12” up from the bottom of each (1891) Post on the Front of the
assembly then place top of Bench Assembly at marked location. The (4931)
Seat Supports should overhang the (1891) Posts by 1”. Make sure the
assembly is level then attach each (4931) Seat Support to the (1891) Posts
with 2 (LS2) 1/4 x 2-1/2” Lag Screws (with flat washer) per support. (fig.
22.4 and 22.5)
F:
Measure 24” up from the bottom of each (1891) Post on the Front of the
assembly then place top of (4932) Table Supports at marked location. The
(4932) Table Supports should be flush to the inside edge of (1891) Posts.
Make sure the assembly is level then attach each (4932) Table Support
to (0369) Lower Diagonals and (1891) Posts with 2 (LS2) 1/4 x 2-1/2” Lag
Screws (with flat washer) per support. (fig. 22.4 and 22.5)
1891
Fig. 22.5
1/4” Flat
Washer
Hardware
8 x
1/4 x 2-1/2” Lag Screw (1/4” flat washer)
LS2
Step 22: Table Top and Bench Assembly
Part 2
Fig. 22.4
0369
LS2
x 8
4932
4931
4931
4932
24”
12”
Front
1”
Summary of Contents for F23850
