Big Backyard F23850, Installation And Operating Instructions Manual

Page: 16 / 56

16
support@solowavedesign.com
Step 2: Rock Wall Assembly
A: Lay 2 (0349) Rock Rails down, side by side with angled edges facing down. (fig. 2.1)
B: Place (1779) CE Access Board on the bottom of each (0349) Rock Rail as shown in fig. 2.1. Make sure (1779)
CE Access Board is flush to the outside and bottom edges of each (0349). Attach using 4 (S2) #8 x 1-1/2” Wood
Screws.
C: 7-3/4” down from the top of both (0349) Rock Rails place 1 (1777) CE Rock Board B, making sure the sides are
flush to the outside edges of each (0349) Rock Rail. Attach using 4 (S2) #8 x 1-1/2” Wood Screws. (fig. 2.1)
D: In between the (1779) CE Access Board and (1777) CE Rock Board B stagger 2 (1778) and 2 (1777) CE Rock
Boards A & B using 4 (S2) #8 x 1-1/2” Wood Screws per board. Placing them as shown in fig. 2.1, this will prevent
rocks from forming a straight line. Make sure the boards are evenly spaced and do not exceed 2-3/8” between
boards.
E: Place 1 rock on each (1777) and (1778)
CE Rock Board A & B (fig. 2.2) and attach
using 1 (PB2) 1/4 x 1-1/4” Pan Bolt (with lock
washer, flat washer and barrel nut) and 1
(S10) #8 x 1” Pan Screw per rock. The Screw
must be in the hole directly under the Pan
Bolt, it will stop the rock from spinning. (fig.
2.3)
Note: Gaps between boards 2-1/4”,
not to exceed 2-3/8”
Note: The holes
in the rock boards
must orient to the
top of the boards.
Fig. 2.1
S2
1779
0349
1778
1777
1777
1777
1778
Fig. 2.2
Fig. 2.3
1 x CE Access Board 1 x 6 x 17”
3 x CE Rock Board B 1 x 6 x 17”
2 x CE Rock Board A 1 x 6 x 17”
2 x Rock Rail 2 x 3 x 51”
24 x #8 x 1-1/2” Wood Screw
5 x
#8 x 1” Pan Screw
5 x 1/4 x 1-1/4 Pan Bolt
(1/4” lock washer, 3/16” flat washer & 1/4” barrel nut)
S2
0349
1778
1777
1779
3/16” Flat
Washer
1/4” Lock
Washer
1/4” Barrel
Nut
Rock
5 x Rocks (3 green/2 yellow)
S10
S10
Wood Parts Hardware Other Parts
PB2
PB2
7-3/4”
Approx