15
in Figure 2. When both hands are placed
on the sensors the heart symbol on the
right-hand side of the screen, marked
PULSE, will begin to flash and after a
few seconds a heart rate reading will be
displayed.
If both hands are not placed correctly as
shown in figure 3 then the pulse function
will not work.
If a «P» appears on the screen or the
heart symbol does not flash, make sure
that both hands are placed correctly on
the sensors.
TELEMETRIC PULSE RATE
The console is equipped to receive
signals from a telemetric pulse
measurement system. The system is
comprised of a receiver (D) and a
transmitter (chest band) Fig 4.
This telemetric pulse rate system
takes precedence over the Hand-grip
pulse rate system when both are used
together.
TEST MEASUREMENTS: FITNESS
This console is equipped with a recovery
test function. This offers you the
advantage of being able to measure how
long it takes your heart rate to recover
after having finished the exercise. Upon
finishing the exercise leave your hands
on the pulse sensors (R) and press the
«Recovery» button, this will start a one
minute countdown. Only the Time and
Pulse rate function read-outs will remain
displayed. The console will measure your
pulse rate during this minute. The heart
rate recovery time will be displayed on
the Heart rate line.
If, at any time during this minute, you
decide to abandon this test then press
the «Recovery» button and this will take
you back to the main screen.
When the minute is up, the console will
work out the difference and your fitness
rating will be displayed up on the screen:
«F1, F2,..., F5, F6»; where «F1» is the
best (fitness «Excellent») and «F6» the
worst (fitness «Very Poor»).
Pressing the RECOVERY button will
take you back to the main screen, where
the functions will be in the same mode as
when the test began.
The comparison between the worked
heart rate and the recovery heart rate
provides a fast, simple method of
gauging how fit you are. Your fitness
rating is a guideline that shows you how
fast your heart recovers after physical
exertion. If you exercise regularly then
you will see your fitness rating improve.
The test does not work unless you have
both hands placed on the sensors (R)
(Hand-grips). In this case the message
«F6» will appear on the screen at the
end of the test.
TROUBLESHOOTING GUIDE
Problem:
The display comes on but only the Time
function works.
Solution:
a.- Make sure that the connection cable
is connected.
Problem:
Display segments of a function readout
are not visible or error messages for a
particular function appear.
Solution:
a.- Finish the exercise or unplug it from
the wall outlet for 15 seconds and then
plug it back in.
b.- If the above steps do not help then
replace the console.
9V Transformer
Problem:
The console does not switch on.
Solution:
a.- Check the wall outlet connection
b.- Check the output connection from the
transformer to the machine.
c.- Check the cable connections for the
main post.
Avoid leaving the console in direct
sunlight as this might damage the liquid
crystal display. Similarly, do not expose it
to water or shock.
Summary of Contents for IRIDIUM AVANT
