8
English
FITTING THE BATTERIES.
This monitor uses two 1.5 volt R6 AA
ALKALINE BATTERIES. To fit the
batteries, remove the rear cover on
the monitor, Figure 1, and carefully
insert the two “R-6 AA” type batteries
into the battery compartment (A)
making sure that the battery’s polarity
is correct (matching the battery’s «+»
terminal with the «+» sign inside the
battery compartment, and the «-»
terminal with the «-» sign). Close the
cover, as shown in Figure 1.
If, after having switched the monitor
on, it displays errors or merely partial
segments then remove the batteries
and wait for about 15 seconds before
reinstalling them.
Weak batteries (run down) produce a
weak digital display (poor contrast)
and erroneous readings. Change them
immediately.
The monitor will switch itself off
automatically if the unit remains
motionless for 3 minutes.
Important.
Discarded batteries must
be deposited in special containers,
Figure 2.
FITTING THE ELECTRONIC
MONITOR.
Take the monitor (P) and remove the
four screws (C) from the base of the
monitor, Fig. 1, connect the terminals
for the feedback cables (53a) coming
out of the monitor to the cable (53)
sticking up out of the handlebar stem,
Fig. 3, then plug the terminal (54)
which is also sticking out of the
handlebar stem into the hole (54a) on
the base of the monitor, position the
monitor on the handlebar stem,
making sure not to catch any of the
cables, and attach it using the four
screws (C) removed previously.
ELECTRONIC MONITOR
To give you greater control over the
exercise, this electronic unit provides
simultaneous read-outs of speed,
distance, exercise time, calories burnt
and pulse rate.
The screen will switch itself on
automatically as soon as you start
exercising or by pressing any key.
The monitor will switch itself off
automatically if the unit stands idle for
more than 3 minutes.
A.SCAN FUNCTION
In SCAN mode the computer
continuously scans and displays all of
the functions during exercise. The
function being displayed will flash on
and off.
To select the SCAN function:
1.
The monitor starts in SCAN mode
as soon as exercise begins or if any
key is pressed, the main screen will
display TIME, SPEED, DISTANCE,
CALORIES, PULSE RATE values
every 8 seconds, this value will also
be displayed flashing on the lower
section of the monitor.
2.
Press the MODE key and this will
cancel the SCAN function.
B.TIME FUNCTION
This function counts up or down in
steps of one second, up to a
maximum of 99:00 seconds. Pressing
the R-set key for more than two
seconds will reset all of the values,
