BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
OPERATION
1. Remove the sealing cap from the compressed air inlet (6).
2. Mount the compressed air nipple on the compressed air inlet.
3. Put a few drops of compressed air device oil into the device via the air inlet.
4. Make sure that the trigger lever (3) is in the non-depressed position.
5. Connect the device to the compressed air source hose.
6. Start the device by pushing the safety lever (4) forward and the trigger lever (3) down.
Note: Take the time to carefully select a work area.
Let the tool work independently without exerting extreme pressure! Excessive pressure reduces the
speed of the cutting disc and thus the cutting performance. In addition, the engine is unnecessarily
heavily loaded. Start the tool in front of the workpiece, then place it evenly on the workpiece and
move it in the desired direction to make the cut. After the cut, detach the tool from the workpiece and
then stop the motor.
By turning the adjusting wheel (
1
),
the desired speed can be adjusted in four steps
and read on the marking (
2
).
CHANGING CUTTING DISC
Fig. 1
Fig. 2
Fig. 3
Caution:
Disconnected air tool from air supply before replacing the cutting disc or other maintenance
work.
1.
Turn the cutting disc by hand until the shaft lock is visible and the counter holding wrench can be
attached (Fig. 1).
2.
Loosen and remove the locking screw with the internal hexagon (Fig. 2).
3.
Replace the old cutting disc with a new one.
Caution:
Observe the information on the cutting disc. Suitable for type 41 cutting discs.
4.
Tighten the locking screw with hexagon socket and counter holding wrench, after changing (Fig. 3).
ENVIRONMENTAL PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All parts of
packaging should be sorted, taken to a recycling centre and disposed of in a manner
which is compatible with the environment. Contact your local solid waste authority for
recycling information. Dispose of this product at the end of its working life
environmentally.
1
2
