BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Art. 9530
Hydraulic Cylinder
TECHNICAL DATA
Cylinder capacity: 10000 psi (700 bar)
13.0 metric ton
14.3 US ton
Stroke: 42 mm
Oil capacity: 77.7 cm³
Retracted height: 120 mm
Extended height: 162 mm
Collar thread: 2-3/4”x16, length 30 mm
Outside diameter: 70 mm
Center hole diameter: 19.5 mm
Weight: 2.8 kg
ADAPTORS
1-
Male adaptor, 1/4'' NPT (inner thread)
2-
Female adaptor, 3/8'' NPT (outer thread)
3-
Switch adaptor, 1/4'' NPT (outer) to 3/8" NPT (inner)
Please read and follow this instruction before you use cylinders.
SAFETY
To avoid personal injury or property damage, please follow all safety precautions.
DANGER
is only used when your action or lack of action may cause serious injury.
WARNING
indicates a potential danger that requires correct action to avoid personal injury.
IMPORTANT
indicates correct action to prevent damage or equipment failure.
DANGER
•
The hydraulic equipment operator must be a qualified operator familiar with correct training and
work experience of hydraulic equipment. Lack of knowledge in any of these areas can lead to
equipment damage or personal injury.
•
Please carefully inspect cylinder(s), coupler(s) and hose(s) before use hydraulic equipment, if you
find any damage on the cylinder(s), coupler(s), and hose(s), please stop using your equipment.
These damages may cause equipment failure and possible personal injury.
•
Please never lift a load more than the capacity of the cylinder(s), overloading will cause
equipment failure and possible personal injury.
•
The operating pressure of cylinder(s) are designed for a max pressure of 700 bar (10,000 psi),
please do not use a pump or relief valve with a higher pressure rating to connect the cylinder(s).
Higher pressure pump or relief valve may cause equipment failure and possible personal injury.
•
Cylinder is a load lifting device, not a load holding device. After the load has been raised or
lowered, it must always be held mechanically. Please never work under a load supported by
hydraulic.
•
To avoid personal injury, please keep hands and feet away from cylinder(s) and workplace during
operation.
•
Please do not put poor-balanced or off-center loads on cylinder(s). The incorrect load can result
in equipment failure and possible personal injury.
