BGS technic 9231, Assembly Instructions Manual

Page: 5 / 13

BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
ASSEMBLY INSTRUCTIONS
Warning
: During the assembly procedure, nuts and bolts should be hand tightened only. Once
assembly is complete, nuts and bolts must be fully tightened.
1. Attach two front wheels (#19) to front beam (#20) using nuts (#17) and lock washers (#18).
2. Attach front beam assembly (#20) to middle beam (#16) using bolts (#9), nuts (#11 ) and lock
washers (#10).
3. Attach main post (#5) to rear beam (#14) using bolts (#9), nuts (#11 ) and lock washers (#10).
4. Insert middle beam assembly (#16) to the tube of main post (#5) and secure it with bolt (#15).
5. Insert rotating plate (#3) through the tube at the top of the main post. Rotate the plate till one of
the holes in the inner tube is aligned with a hole in the outer tube and insert the ringed pin (#4).
6. Insert the handle (#1) through the hole in the rotating plate tube which protrudes from the top off
the main post.
7. Attach four fingers (#2) to the rotating head (#3) using bolts (#8), flat washers (#6) and nuts (#7).
8. Check all bolts for tightness before operating.
EXPLODED DRAWING
N° Description QTY
1 Handle 1
2 Finger 4
3 Rotating Plate 1
4 Pin 1
5 Main Post 1
6 Flat Washer Ø14 10
7 Nut M14 4
8 Bolt M14x65 4
9 Bolt M10x75 4
10 Lock Washer Ø10 4
11 Nut M10 4
12 3" Rigid Wheel 2
13 Split Pin 2
14 Rear Beam 1
15 Bolt M12x25 1
16 Middle Beam 1
17 Nut M12 2
18 Lock Washer 012 2
19 3" Swivel Caster 2
20 Front Beam 1