BGS technic 2170, Instruction Manual

Page: 28 / 33

BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
12
8.4 Heating timer
The timer makes it possible to automatically stop heating after a set amount of time, enabling
accurate dosing of energy (heat) introduced to the material, e.g., for spot or repeated heating to a set
temperature.
Press the encoder repeatedly until the

TIMER indicator lamp glows red

. Turn to set the desired
heating time in seconds or deactivate the timer by selecting “OFF“.
If the timer is set, then the indicator lamp glows green

when the heating starts, and if the heating
is stopped by the timer, the indicator lamp starts flashing green

and the display shows the letters
“OFF” once the button is released. Releasing the button stops the heating immediately.
Note: If heating is started in the timer settings, the display will show the remaining heating time
(remaining heating time countdown).
Note: Press the encoder to enter pre-heating/program settings (see following chapter). To exit to
power settings immediately, press and hold down the encoder.
Indicator lamp Status

red heating time settings

green timer active – heating in progress

green, flash
timer active – timeout
8.5 Info
Info enables display of basic information about the heating process and the device. It thus facilitates
selection or optimisation of induction coils for the material to be heated, removal of any problems, etc.
If you wish to display Info, press the encoder repeatedly until the indicator lamp glows red

.
Turn the encoder to select the parameter to display and press to confirm. The display shows the latest
reading (indicator lamp glows green

),
or shows the current reading during the heating (indicator
lamp flashes green

).
Press again to return to parameter selection, and you can select another one. If you wish to exit the
Info display and continue to further settings, select “---” in the parameters and press to confirm. To
exit to power settings immediately, press and hold down the encoder.
Indicator lamp Status

red parameter selection

green, flash latest reading

red, flash current reading during the heating
The following parameters are available in Info
Description Display Value Unit
Return / exit ---- ----
Power transmitted P 0.01 kW
Output power Po 0.01 kVA
Power factor PF 1%
Frequency FrE 0.1 kHz
Input current OC 0.1A
Output current IC 0.1A
Input voltage VOL Vrms
Cooling temperature tEP 0.1°C
Limit OL
--- = without limit
po = max. transmitted power
ic = max. input current
oc = max. output current
dut = max. duty inverter
tE = temperature
Error Err error history
Note: see annex for a list of errors.