Bexen REANIBEX 300, User Manual

Page: 61 / 102

DIH 0300 B – USER GUIDE REANIBEX 300 47
8 CONFIGURATION
Figure 30: Equipment ID Code modification screen
5. Use the programmable buttons and the key to change the IDENTIFIER of the equipment.
6. After changing the IDENTIFIER of the equipment, exit this menu option using the button .
7. A screen will appear requesting confirmation of the changes that have been made.
8. Press the programmable button to save the changes to the IDENTIFIER of the
equipment.
8.4.2 DEFAULT SETTINGS
WARNING
POSSIBLE INCORRECT OPERATION OF THE EQUIPMENT
Changing the configuration of the equipment’s factory default values will affect the operation of the
equipment. Changes to the default configuration must be performed by authorised personnel.
Take the following steps to reuse the configuration changes entered initially:
1. Switch on the REANIBEX 300 in Configuration mode.
2. Enter the Configuration mode access password.
3. Use the programmable buttons to access the “CONFIGURATION MANAGEMENT” menu option
.
4. Select and open the “DEFAULT VALUES” option.
5. When the confirmation request screen appears, press the programmable button to
load the default settings.
6. While the default factory settings are being restored, the REANIBEX 300 will display the message
“ Restoring default settings... ”.
7. If the configuration is loaded successfully, the REANIBEX 300 will display the following message
for a few seconds: “ Default settings restored ”.
8. Exit this menu option.