9
7.2 Connecting the ANTELOPE.SUIT to the ANTELOPE.8CH
BOOSTER
DO NOT CONNECT THE ANTELOPE.SUIT TO THE ANTE-
LOPE.8CH BOOSTER WHEN THE BOOSTER IS SWITCHED ON.
1. There is a button grid on the back of the BOOSTER. On the
ANTELOPE.SHORTS there is a plug-in strip with buttons. Place the
SHORTS connector on the lower part of the BOOSTER to connect
the two.
2. On the side of your ANTELOPE.SHIRT there is another button
grid, the baseplate. To connect the SHIRT to the BOOSTER, place
the BOOSTER on the baseplate.
7.3 Switching the ANTELOPE.8CH BOOSTER on and off
• On: Press and hold the [+] button for three seconds.
•
Off: Press and hold the [-] button for three seconds.
7.4 Connecting the ANTELOPE.8CH BOOSTER with the
ANTELOPE.APP via Bluetooth
The ANTELOPE.APP must first be downloaded from the App
Store or the Google Play Store. Android users and iOS users
must activate the location function of their device to use the app.
1. Press and hold the [+] button on the BOOSTER until the LED
lights up green.
2. Activate Bluetooth on your device.
3. Open the ANTELOPE.APP on your device and select the tab
“Connect”. The BOOSTER is displayed at this point. Tap on the
BOOSTER to connect it to the app and fill in the displayed fields to
continue.
If the app is connected via Bluetooth, the BOOSTER’s LED
changes to a constant blue light.
If the connection to a Bluetooth device is interrupted for
several minutes, the BOOSTER will NOT switch off
automatically. If a connection between the Bluetooth
device and the BOOSTER is disturbed, immediately disconnect the
connection between the BOOSTER and the baseplate.
7.5 Starting the stimulation
The stimulation can only be started via the ANTELOPE.APP.
The APP and BOOSTER must be connected beforehand.
1. Tap on the EMS tab of the ANTELOPE.APP and select a pro-
gram.
The duration of each program can be adjusted.
2. Tap on “Start“ at the bottom of the screen to start the stimula-
tion.
7.6 Regulating the stimulation
• After the start, the stimulation can be regulated via the ANTE-
LOPE.APP and/or directly via the BOOSTER.
• By pressing [+] on the EMS tab of the APP or the BOOSTER,
the intensity is increased by one unit on all channels.
• Pressing [-] on the EMS tab of the APP or the BOOSTER will
decrease the intensity by one unit on all channels.
If the stimulation is not noticeable at a displayed intensity
of 25%, switch off the BOOSTER and apply the ANTELOPE.
ELECTRODE CONTACT RAY directly to the electrodes in the
textile. Then restart the ANTELOPE.APP and make sure that all
intensity levels are set to 0. Once this process is complete, start
using your ANTELOPE.SUIT again according to these instructions
for use.
