Beurer GL50 evo
33
Note
• Do not store the device, test strips and control solution in your vehicle, in the bathroom or in a cooling
appliance.
• Retain these instructions for use.
• Only clean the device when it is switched off.
• The device needs to be in the location in which the measurement will be taken for at least 30 minutes
before use so that the device can adapt to the ambient temperature. Please ensure that the operating
range is b10°C and +40°C. Accurate measurement results cannot be guaranteed if a
measurement is taken outside of this temperature range.
7.1 Maintenance
Clean the surface of the device using a soft, slightly damp cloth (water or a mild cleaning solution).
Dry the device using a lint-free cloth.
Make sure that moisture does not enter the test strip insertion slot. Do not spray cleaning products
directly on the device. Do not submerge the device in water or any other fluids and make sure that
no fluids can get into the device.
7.2 Disinfection
Please comply with the generally applicable guidelines on disinfection when using the device on
different persons. Do not submerge the device in disinfection solutions or any other fluids and make
sure that no fluids can enter the device.
The cap on the integrated lancing device can be disinfected with 70 – 75% alcohol. Disinfect the cap
at least 1 x a week and submerge the cap in alcohol for approx. 10 minutes. Allow the cap to air dry.
Note
The monitor is made of precision components. The accuracy of the measurements and service life
of the device depend on its careful handling:
• Protect the device from impacts and do not drop it.
• Protect the device from damaging factors such as moisture, dirt, dust, blood, control solution or
water, marked temperature fluctuations, direct sunlight and extreme cold.
• Do not use the device in the vicinity of strong electromagnetic fields, radio systems or mobile
telephones.
• If the device is used in a dry environment, in particular near synthetic materials (clothes containing
synthetic fibres and carpets, for example), the damaging static charges which occur may cause
erroneous results.
• Do not use the device near sources of strong electromagnetic radiation, as this may affect normal
operation.
• It is a good idea to carry out an assessment of the electromagnetic environment before using the
device commercially.