24
Beurer GL50 evo
Note
• Do not apply blood to the sides of the test strips
• Do
not
add blood later if the device does not start measurement. Remove the test strip and end this
test. Use a new test strip.
• If the test strip has already been inserted into the device but no blood is added to the test strip within
two minutes, the device switches itself off. Briefly remove the test strip and reinsert it so that the
device automatically switches itself back on.
• Contact Customer Services if you are unable to fill the test strip with blood correctly.
5.4 Reading the result and marking measurements
Reading the result
As soon as the blood input gap is filled with sufficient
blood, the device performs the blood glucose
measurement. The monitor counts down for approx. five
seconds. The measurement is then shown on the display.
MEMORY
MEMORY
Read your measured value. Check again that you have read the result correctly. The underline must
be below the measured value, otherwise you need to turn the monitor by 180°. For explanations of
and measures regarding the measured values, see “5.6 Evaluating measured blood glucose values”
on page 26. If an error message is displayed, read chapter “8. What if there are problems?” on
page 34.
Marking the measurement
You have the following options for marking measured values:
O
No marking
Before meal
After meal
General marking (e.g. after exercising).
Marking measured values enables you, your GP or diabetes consultant to better monitor your blood
glucose values. For example, you can display the average values of all measurements taken before
a meal.
