BETCO STEALTH DRS24BT, Operator And Parts Manual

Page: 51 / 64

51
ALARM AND WARNING TABLE
A1 FORWARD GEAR TURNED ON DURING SWITCHING CONTROL THE MICRO FORWARD GEAR
A2 REVERSE GEAR TURNED ON DURING SWITCHING CONTROLS THE MICRO REVERSE GEAR
A3 TEAR POTENTIOMETER CONTROL THE CABLES OF THE POTENTIOMETER
A4 POTENTIOMETER NOT SET TO ZERO
DURING SWITCHING – SET THE POSITION OF THE ZERO POINT OF THE POTENTIOMETER
A5 THERMAL PROTECTION (it activates at temperature
over 190° F, causing stopping of the machine, until the
temperature is below limits – control the value of
temperature with the parameter F14=4)) CONTROL THE ABSORPTION OF THE MOTOR – INCREASE THE DISSIPATION
A6 SHORT MOS DURING THE SWITCHING SWITCH OFF, VERIFY AND SWITCH ON AGAIN. CONNECTIONS.
IF IT PERSISTS CHANGE THE OPERATION.
A7 OVER CURRENT LINE 1 CONTROLS THE MOTOR OR – DECREASE THE MAX. CURRENT
A8 OVER CURRENT LINE 2 CONTROLS THE MOTOR OR – DECREASE THE MAX. CURRENT
A9 UNDER VOLTAGE VOLTAGE < 18V CONTROLS THE CONNECTIONS AND THE SECTION OF THE
CABLES OF POWER
A10 OVER VOLTAGE VOLTAGE > 45 V
A11 AMP PROTECTION CONTROLS THE CURRENT OF THE MOTOR
A12 DISABLE CONTROLS THE CONNECTION OF THE PIN 6
A13 ALARM SWITCHING OFF CONTROLS THE KEY AND THE CORRESPONDENT CONNECTION
A14 ALARM EEPROM SWITCH OFF AND SWITCH ON AGAIN
Message Purpose Alarm
Alarms or warnings stop the machine. The number of the alarm occurred is readable by the console display or counting the
fl ashes of the alarm led. The number of fl ashes matches with the alarm number (for example 4 fl ashes are equal to A4).
PROGRAMMING THE TRACTION CARD
To enter into the programming functions, push “MODE”.
Then will appear the text indicating the fi rst parameter ( “F0” ); pushing “UP” and “DOWN” to select the required parameter.
Push “MODE” to enter into the modes of the change and push “UP” and “DOWN” to obtain the required value; when it’s se-
lected, confi rm another time the new value with “MODE”.