53
POTENTIOMETER CALIBRATION
1. Be sure that the machine is turned off.
2. Connect the programming console to the traction card and then turn on the machine.
3. A check out message (like - –3 or similar will fl ash few times) will be shown and then “0” will appear.
4. Push the ENTER button, “F1” will appear.
5. Push the “UP” button until “F20” appear and then press the Enter button to be able to change the parameter 20.
6. Push the “UP” button to set the parameter at “1” then confi rm the value with the ENTER button.
7. Wait until the console shows “0”.
8. Push simultaneously the “UP” and “DOWN” keys and keep them pressed for few seconds.
9. The low fl ashing segment and the potentiometer voltage value will appear.
10. With pedal in idle condition press “ENTER” to store in the traction card the idle potentiometer value.
11. Then a the high segment will start to fl ash.
12. Push the accelerator pedal to its end stroke and, keeping it pressed, push the “ENTER” button to store in the traction card
the maximum potentiometer value.
13. Wait until on the console “0” appears.
14. Then push the “ENTER” button to let “F1” appear.
15. Push the “UP” button until “F20” appear and then press the “ENTER” button.
16. The console will show the number 1 which is the value of the parameter 20.
17. Push the “DOWN” button to set the parameter 20 to 0 and confi rm with the “ENTER” button.
18. Wait until the console shows the number “0”.
19. Turn off the machine and restart it.
20. The Accelerator Programming is fi nished.
21. Be sure to disconnect the console only if the machine is turned off.
ELECTRIC PLANT TEST
1. Disconnect the supply plug.
2. Check the connections of the battery cables.
3. Check the tightness of power cables,
relays, fuses (RXE)
motors etc.
4. Check the conditions and the right values of
fuses
.
5. Check the functionality of
traction micro switch
.
6. Check that the potentiometer support is adjusted so if the potentiometer is at maximum
travel the pedal touches the bottom plate. This is to prevent potentiometer damage.
7. Connect the battery plug.
8. Turn on the machine with the key switch.
9. Check the lamps and the switches:
• Check the functionality of
battery level LEDS
.
• Check the functionality of the horn.
• Check the functionality of
forward back switch
.
Summary of Contents for STEALTH DRS24BT
