BETCO STEALTH DRS24BT, Operator And Parts Manual

Page: 13 / 64

13
1. After work is complete and before performing maintenance, perform the fol-
lowing operations:
2. Turn off the water control knob ( 1 ) by pressing down on the knob
3. Place the brush deck raise/lower switch in the raised position until the brush
deck is completely raised.
4. Place the squeegee raised/lowered switch ( 1 ) in a central position so that the
vacuum motor continues to operate to empty the vacuum hose for about 20
seconds, and then place it in the fully raised position.
5. Drain the water.
6. Turn the ON/OFF key switch a quarter of a turn counterclockwise (
2 ).
7. Detach the drainage hose from the clip, unscrew the cap and empty the
recovery tank. You should keep the hose higher than the level of water in the
tank with one hand and unscrew and remove the cap with the other. Then
lower the hose slowly.
WARNING: This must be done wearing gloves to protect from con-
tact with dangerous solutions.
8. The squeegee must be raised when the machine is not in operation to avoid
distorting the squeegee blades.
9. Remove the brushes and clean them with water.
WARNING: This must be done wearing gloves to protect from con-
tact with dangerous solutions.
SHUTTING DOWN THE MACHINE