2
111
E
N
G
IN
E ASS
E
M
B
LY AN
D CO
NTRO
LS
Application of circlip 5 to piston.
Identification of piston right and left side.
Preparation of ring compression band A.
Abundantly lubricate the seats for the pin
bolt with motor oil and the circlip
5
in the
left pin bolt seat, being careful to position it
so that the lug on the circlip inserts itself in
the specific seat on the piston.
In order to identify the right and left side of
the piston, just use as a reference the arrow
A
stamped on the piston crown which must
face the exhaust manifold.
APPLICATION OF PISTON TO
CYLINDER
To couple the piston to the cylinder, place
the cylinder while keeping the top facing
upwards. Oil the cylinder with plenty of mo-
tor oil.
Prepare the ring compression band
A
(code
006140170000) as shown in the figure.
Press the green locking lever
B
and turn the
hex key anti-clockwise until the band rea-
ches a dimension near that of the piston.
Oil the inside of the band abundantly and
insert the piston with all its rings inside of
it. Press the green locking lever again and
turn the hex key clockwise to tighten the
rings and piston well.
Attention:
the compression band has edges
which could be sharp. Be very careful when
handling it.
2
.17
.13
A
A
B
Right
Left
5
