Beta ALP 200, Manual

Page: 104 / 408

ADJUSTMENTS
36
EN
3
HEADLIGHT
•The light beam is adjusted by unscrewing
or tightening screw
A
.
By tightening screw the light beam is
lowered; loosening screw raises the light
beam.
•Place the vehicle on level ground (but
not on the stand) 10 metres from a verti-
cal wall.
•Measure the height of the headlight cen -
tre above the ground and then draw a
cross on the wall at 9/10 of the height
of the headlight centre.
•Turn on the low beam, get on the motor -
bike and check that the headlight beam
on the wall is slightly lower than the cross
drawn previously. Where this is not the
case, proceed to adjustment.
•Periodically check the direction of the
beam. The beam can only be adjusted
vertically.
9/10 h
10 m
h
A